Design Your Own Buyer Reviews Download Brochure

Deluxe Chemical Chlorine Starter Pack

£75

Quantity

 

Details

This Chemical Chlorine starter packs consist of 9 different products to help keep your hot tub clean and sanitized. Chlorine is a good sanitizer for hot tubs as it dissolves fast and works well in hard or soft water.

The Deluxe Chemical Chlorine Starter Pack Consists Of

  • 1kg Stabilising Chlorine Granules - Stabilising Chlorine granules are manufactured with a stabilising agent to help prevent the destabilisation and destruction of the chlorine by sunlight and UV rays.
  • 1kg pH Plus (Sodium Carbonate) - pH plus is a powdered additive that can be used to raise the pH to a desirable level.
  • 1kg pH Minus (Sodium Bisulphate) - pH reducer can be added directly to the pool water to reduce the pH a desirable level.
  • 3 Way Testing Strip x 50 - 3 Way Testing strips which help to give readings on chemical balances.
  • 1 Litre Anti Algaecide - Algaecide is a liquid solution and is used to destroy the algae and prevent future growth.
  • 1 Kg Dechlorinator - This dechlorinator is a crystal additive that can be used to reduce and lower the chlorine/bromine level where overdosing has occurred.
  • 1 Litre Pool Clean - Pool clean is a liquid product that flocculates (coagulates) these particles into larger clusters so they can be filtered out of the water.
  • 1 Kg Alkalinity Builder - Alkalinity builder can be used to increases the alkalinity level in hot tubs.
  • 1 Kg Non Chlorine Shock - Once a week dose of 2 x teaspoons for average size hot tubs keep the spa water clear and clean

Treatment

 

Stabilising Chlorine Granules

1, as above
2, Test the water with testing strips to check free chlorine levels.
3, To increase the free chlorine level by 2.5ppm add 5 grams of granules (1 x teaspoon).
4, On average 2 x teaspoons are required as a daily treatment.
5, Use a plastic spoon.
6, Test water balance and chlorine levels daily and before use.
7, It is recommended to add non chlorine shock on a weekly basis to help with the oxidisation (reduction in contaminants).

pH Plus

1, Add 11 grams per 1,000 litres of spa water. (1 teaspoon = 5 grams).
2, Dissolve in warm water in a plastic bucket and distribute evenly around the pool with the pump operating.
3, Leave for 8 hours then re-test to ensure pH level 7.2 - 7.6.
4, Add more if required until correct balance is achieved.

pH Minus

1, Add 5g (1 teaspoons) to 1 litre of warm water and carefully add the solution to the spa whilst the pumps are turned on.
2, Check water balance level with a testing strip and add more Ph Minus if required.
3, Aim for a pH level of between 7.2 - 7.6.

3 Way Testing Strips

1, Dip one strip into water for 5 seconds with a simple back and forth motion
2, Remove strip and shake to remove excess water
3, Wait 15 seconds
4, Match pH, free chlorine / bromine and total alkalinity to the colour chart.
Complete colour matching within 30 seconds.

1 Litre Algaecide

Algae already within system:
1, Shock dose with 20 millilitres per 1,000 litres of spa water (3 ½ teaspoons)
Prevention of algae growth:
1, Add 2.5 ml per 1,000 litres of spa water each week to help prevent future growth. (½ a teaspoon)

Dechlorinator

1, Mix crystals in a 5 litre bucket of warm water & when dissolved add to spa water.
2, 10g (2 teaspoons) will treat 2000 litres of water and reduce the level by 1 mg/ litre.
3, Wait 1 hour and test water balance with testing strips
4, Add again if necessary to reach the right level of chlorine/ bromine

1 Litre Pool Clean Clarifier

Shock dose - Dose approximately 100ml per 1000 litre of spa water
Pool clean be used as part of a daily cleaning routine to help keep water clear and free from dirt if in a frequently used environment.

1 Kg Alkalinity Builder

1, 5 grams (1 x teaspoon) will increase the alkalinity level by 2 ppm in a 1,000 litre spa.
2, Add alkalinity builder to 2 litres (around 1 pint) of warm water and pour dissolved solution into spa water
3, Run pumps for 5 minutes
4, Wait 1 hour and test again with testing strips
5, Repeat dose if required until correct level is reached.

1 Kg Non Chlorine Shock

1, Add 10 grams (2 x teaspoons) to spa water once per week
2, Run pumps for 5 minutes.
3, Place cover on spa and leave for 1 hour before re use.

Storage and Handling

  • Store in a cool Dry Place
  • Keep out of reach of children
  • Do not get in eyes, on skin or on clothing
  • Wear protective gloves/protective clothing/eye protection/face protection

Need some help and advice? Call 0116 251 3378 now to speak to our team

Accreditations

Accreditaitons
Accreditaitons

© Zspas 2015. Powered by Webfuel